The SetInBandDtmfEventTrigger API procedure is used to fine tune how the media engine handles incoming DTMF events. Generally speaking, application software should not call this API procedure unless directed by LanScape support.

Namespace:  LanScape
Assembly:  LMEVoipManaged (in LMEVoipManaged.dll) Version: 6.0.5226.26700


public VoipMediaEngine..::.TELEPHONY_RETURN_VALUE SetInBandDtmfEventTrigger(
	int PhoneLine,
	uint DtmfEventTriggerMs
Visual Basic (Declaration)
Public Function SetInBandDtmfEventTrigger ( _
	PhoneLine As Integer, _
	DtmfEventTriggerMs As UInteger _
Visual C++
VoipMediaEngine..::.TELEPHONY_RETURN_VALUE SetInBandDtmfEventTrigger(
	int PhoneLine, 
	unsigned int DtmfEventTriggerMs
public VoipMediaEngine..::.TELEPHONY_RETURN_VALUE SetInBandDtmfEventTrigger(
	int PhoneLine,
	UInt32 DtmfEventTriggerMs


Type: System..::.Int32
The zero based phone line to access.
Type: System..::.UInt32
Specifies the event trigger time in milliseconds.

Return Value

If the function succeeds, the return value will be SipSuccess.

If the function fails, the return value will be one of the following values as specified by the VoipMediaEngine..::.TELEPHONY_RETURN_VALUE data type.

Return ValueDescription
This value is returned by telephony API procedures to indicate general API failure. This error value is used as a "catch all error". If you receive this error, check to make sure that all parameters specified in the API procedure call are correct. Particularly, verify that pointers to memory regions are valid. This error return value is only used if a mapping to another specific error value does not exist.

(API return value)

Application software specified an invalid telephony handle in one of the API procedures. This usually indicates memory corruption on the part of application software.

(API return value)

Application software called a telephony API procedure and specified an invalid phone line. Phone lines are numbered starting from zero. This error is most commonly returned when attempting to access phone lines in excess of the max number of lines supported by the telephony engine.

(API return value)

The application tried to destroy an RFC2833 DTMF decoder for a phone line using the UnInitializeRfc2833DtmfDecoder(Int32) API procedure and the DTMF decoder did not exists.

(API return value)

Internal media engine in-band and RFC2833 DTMF support has not been enabled. See the DtmfEnabled startup parameter in the VoipMediaEngine..::.START_SIP_TELEPHONY_PARAMS structure for additional information.

(API return value)



See Also